Description
The JMaxX 114A features a 14″ LF woofer with 2″ voice coil 1″ exit throat HF compression driver with 1.4″ voice coil 700W RMS LF, 200W RMS HF DSP with 4-EQ pre-sets all in an incredibly lightweight gas injected moulded polypropylene cabinet. 132 dB SPL. The new FBT JMaxX 114A combines ease of use and versatility for many portable or installed sound applications: musicians, DJs, AVL contractors, rental sound reinforcement, corporate events, houses of worship, bars and clubs.
Processed 2-way active loudspeaker
A 2-way active loudspeaker is a type of audio speaker system that incorporates two separate amplifiers for its two primary components or "ways" of sound reproduction. The two ways typically refer to the speaker's ability to reproduce low-frequency sounds (bass) and high-frequency sounds (treble)
Ease of use and versatility
The new FBT JMaxX 114A combines ease of use and versatility for many portable or installed sound applications: musicians, DJs, AVL contractors, rental sound reinforcement, corporate events, houses of worship, bars and clubs.
2 DSP presets for maximum acoustical flexibility
This preset is designed to adapt to different acoustic environments by dynamically correcting the frequency response based on the characteristics of the room. It uses a combination of equalization and room analysis to optimize audio playback.
DSP with 4-EQ presets
DSP with 4-EQ presets Control panel with: XLR IN and XLR LINK, Volume, EQ presets, HP filter, GND LFT switch.
Configuration: 2 way
Built-in amplifier LF/HF: 700/200 W RMS
Built-in amplifier peak LF/HF: 1400/400 W
Frequency response: 45Hz – 20KHz -6dB
Low Frequency woofer: 14 – 2.5 coil inch
High Frequency driver: 1 – 1.4 coil inch
Maximum SPL cont/peak: 126 / 132 dB
Dispersion: 90° x 60° HxV
Input impedance: 22 K
Crossover Frequency: 1.6 KHz
AC Power requirements: 640 VA
Input connector: XLR with loop, Jack 6.3mm
Power cord: 5 16,4 m/ft
Configuration: 2 Way
Frequency response: 45Hz – 20kHz
Low frequency woofer: 14″ (2.5″ VC)
High frequency driver: 1″ (1.4″ VC)
Maximum SPL cont/peak: 132 dB
Dispersion: 90 x 60
Input connector: XLR + 6.3mm Jack
Net Weight: 14kg
Built-in amplifier LF/HF: 700w/200w
Power cord: 5m IEC